Vinyl Cutter Download Graphtec FC, Vinyl Cutter Machine Download Software Installation & Operation Manual in pdf ( MB) > Download Now. Manually Adjusting the FC ARMS Sensor Level for Glossy Media and Glossy Laminated Prints. When using some glossy media or when using glossy. View and Download GRAPHTEC FC Series user manual online. Cutting Pro . FC Series Plotter pdf manual download.

Author: Zum Shaktimi
Country: Guinea-Bissau
Language: English (Spanish)
Genre: Personal Growth
Published (Last): 11 August 2014
Pages: 211
PDF File Size: 17.20 Mb
ePub File Size: 6.50 Mb
ISBN: 781-3-95524-585-7
Downloads: 56551
Price: Free* [*Free Regsitration Required]
Uploader: Fauhn

Graphtec Manuals and Drivers – SignWarehouse Product Support

Supplement This setting is maintained even if the power is turned off. Page Push roller Setting of the DHCP depends on the structure of the network equipment and the environment. Paper-weight is located under the tool carriage. To print the manual completely, please, download it.

With thick film, additional time is required for the cutter blade to penetrate the media fully, even when the necessary cutting force is applied.

Cutting data in the buffer memory will be cleared. Settings Regarding Cutting Ti It can be set up to 10 mm outside positive value or 10 mm inside negative value from the default position. Setting graptec the Initial Down Force The initial down-force setting is effective when tangential mode is selected.

Running Cutting Tests Test cutting can be performed after making the tool, speed, force, and acceleration settings to ensure that the selected cutting conditions actually produce the desired cutting results.


Assembling the Stand mounting direction is different for the front loading and fc80000 rear loading models. Tool carriage will move away to upper right by continuously performing the same operation.

Therefore, it is Sensor necessary to adjust the coordinate values of the scanned registration mark so it will match with the cutting position. Default setting for page length is 2 m. Sequence of scanning the mark is changed for significantly reducing the mark detection time. The cutting plotter can be configured to this condition using Graphtec mwnual Supporting software: Unplug the power cord from the socket Setting of the Cross Cut Force This will adjust the blade force when it cross cuts.

When two push rollers are used Strong Strong Medium Medium Attaching the Pouncing Tool Operation Loosen the tool holder screw.

Setting the Pouncing Tool Set the distance of the holes when continuous holes are to be punched. Supplement F ollowing screen is displayed, the buffer memory is cleared, and It will return graphtdc operation stop screen without it will return to default screen.

Attaching To The Pen Station Make sure that the tool bracket is engaged on the tool’s fange, and then tighten the screw.

GRAPHTEC FC8000 Series User Manual

Page gc8000 3 Press the [1] key. Perform Automatic Pre Feed When Cut Data is Received It is possible to feed and reverse the media automatically for specified amount when the plotter receives the cutting data.


Setting the Cutting Direction Rotate the coordinate axes to change the cutting direction.

Following items are displayed in the default screen. Aligning the Push Rollers This section describes how to alignment of the push rollers.

Match the setting to the used software, or set it to AUTO. It may not scan the registration marks or the difference may become large when the speed is too high, but the cutting time becomes longer when the speed is too slow.

Page Press the [1] key RSC. Automatically Cross Cut Automatically Cross Cut will automatically cross graphtc after cutting when the cutting is done with provided software.

Graphtec Manuals and Drivers

Supported reversed color mark The sensitivity of the registration mark sensor is automatically set by measuring the reflective level of the actual media. Press the [1] key TOOL. Supplement DHCP setting screen is displayed.

This article was written by admin